Masaüstü için Bilgisayar için Sensör Modülü Hassas Kompakt
Yenilendi

Masaüstü için Bilgisayar için Sensör Modülü Hassas Kompakt

₺ 248.40

Mağazada

0-5 A içinde röle aşırı akım sinyal çıkışı elde etmek için AC sinyalini toplamak için akım trafosu kullanır. Kullanıcılar, aşırı akım koruması elde etmek için harici devreyi açıp kapatmak için röle COM, NC, NO üç bağlantı noktasını kullanabilir. 5 A aşırı akım koruma sensörü modülü.Aşırı akım olduğunda röle çekilir, aşırı akım olmadığında röle serbest bırakılır.Aşırı akım sinyal ayar noktası ayarlanabilir. 5 A aşırı akım koruma sensörü modülü.Röle aşırı akım sinyal çıkışını 0-5 A içinde elde etmek için AC sinyalini toplamak için akım transformatörünü kullanır.Aşırı akım sırasında röle çekme, aşırı akım değilken röle serbest bırakılır.Kullanıcılar, aşırı akım koruması elde etmek için harici devreyi açıp kapatmak için röle COM, NC, NO üç bağlantı noktasını kullanabilir.Aşırı akım sinyal ayar noktası ayarlanabilir.

Teklifin özellikleri

Type:
5A 12V Relay Module
Working voltage:
DC12V
Working current:
Operating frequency range:
20Hz-400Hz
Output mode:
switch signal output
Maximum detection wire diameter:
5.2mm
Mounting hole:
hole diameter is 3mm, hole pitch is 52.5mm
Operating environment:
-40℃ - 85℃
Current detection range:
AC0.3A-5A
Board size:
Approx. 38 * 44mm / 1.5 * 1.7in
Weight:
Approx. 27g
Package list:
1 * Module :
Functions:
Current detection resolution can change the parameter of resistance parameters. :
Output over-current switching signal output. :
Over-current signal setting point is adjustable. :
Board Description:
VCC:
Operating voltage positive;
GND :
Operating voltage negative;
NO:
Normally open, the relay pulls before the NO and COM disconnect, short-circuit after the suction;
COM:
common, relay common interface;
NC:
Normally closed, the relay before the NC and COM short-circuit, after pull off.
Using Instructions:
By setting the potentiometer to set the overcurrent protection point, the clockwise adjustment can reduce the detection current. :
As bellows:
1. Measured the wire through the current transformer , connect VCC and GND to DC12V power supply; :
2. Adjust the potentiometer, when you hear the sound of the relay pull (can be measured with a multimeter, to see i :

Benzer cümleler